Services

AAAC

• Process of Manufacture:
• Wire Drawing:
• Aluminum Alloy Rod of 9.5 mm to an intermediate stage of about 6.0 mm either bobbins or coil.
• Solution Treatment:
• The drawn rod of 6 mm is then loaded in a furnace for heat solution treatment. The materials is then subjected to a temperature of about 500-515°C, soaked for about 30 minutes and quenched in water within 60 seconds, allowing the alloy in the Aluminum to evenly distribute and attain required properties
• Final Wire Drawing:
• The material removed from the water is then drawn to its final size of required diameter corresponding to the Conductor size.
• Ageing:
• The drawn material is then aged in a Ageing Oven at a temperature of 150-200 ̊C for a period of 8-16 hours, again depending on the size of wire drawn. The Ageing removes the stress on the wire and gives elongation properties.
• The Aged material stranded to form the final conductor, wound on wooden drums, and tests as per relevant standards performed before offer to Inspection
•